Brocade Communications Systems RFS6000 User Manual
Page 592
590
Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Wireless configuration commands
20
Sets the rate at which broadcast and multicast
traffic is transmitted
Defines the wireless client configuration
Clears the display screen
Changes settings for cluster master support. This is
required for cluster-level functions
Changes an AP’s mode of operation
Configures the country of operation. All existing
radio configurations are erased.
Debugging functions.
Enables forwarding of DHCP responses to one
portal.
Records wireless client DHCP state information
Enables support for 802.11 shared key
authentication
Ends the current mode and moves to the EXEC
mode
Ends the current mode and moves to the previous
mode
Converts broadcast DHCP server responses to
unicast responses
Displays the interactive help system
Configures Hotspot configuration information.
Sets the user load balance mode
Defines the local MAC authentication list
Allows the manual mapping/un-mapping of WLANs
to configured radios
Configures wireless client parameters
Configures mobility parameters
Sets a multicast packet limit (per second) for a
VLAN
Configures watermarks for handling bursts of
broadcast/multicast frames
Configures the NAS ID to be sent to the RADIUS
server.
Configures the NAS port to be sent to the RADIUS
server.
Negates a command or sets its defaults
Responds to ARP requests from the RON to a WLAN
on behalf of clients
TABLE 22
Wireless Configuration Commands
Command
Description
Ref.