Brocade Communications Systems RFS6000 - Manual (Page 591)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 589
53-1001931-01
Chapter
20
Wireless Instance
In this chapter
• Wireless configuration commands. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 589
Use the
(config-wireless)
instance to configure local RADIUS server parameters associated
with the controller.
To navigate to this instance, use the command from the Global Config mode.
RFController(config)#wireless
RFController(config-wireless)#
Wireless configuration commands
This table summarizes
(config-wireless)
commands:
TABLE 22 Wireless Configuration Commands
Command Description Ref.
aap Sets Adaptive AP (AAP) related commands page 592
admission-control Enable admission control across all radios page 594
adopt-unconf-radio Adopts a radio even if its not yet configured. The
default templates can be used for configuration. page 595
adoption-pref-id Used as a preference identifier for this controller. All
radios configured with this preference identifier are
more likely to be adopted by this controller. page 596
ap Displays access point related commands page 597
ap-containment Defines the Rogue AP containment configuration page 602
ap-detection Defines the AP detection configuration page 603
ap-image Defines the path to upload the new image over an
AP page 604
ap-ip Modifies static IP information for access points page 605
ap-standby-attempts-thre
shold Sets the number of attempts after which the
stand-by controller starts adopting APs page 607
ap-timeout Changes the default inactivity timeout for access
points page 608
ap-udp-port Configures the UDP port for AP L3 adoption. Enable
this option in the DHCP Server supporting this
access-point. page 609
auto-select-channels Configures the channels that will be used when ACS
or DFS is performed. page 610