Brocade Communications Systems RFS6000 - Manual (Page 257)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 255
53-1001931-01
Global Configuration commands
5
local pool default
low-ip-address
{high-ip-address
} Sets the VPN local IP pool configuration
•
pool default low-ip-address {high-ip-address
} – Specifies the address range for the default
group tag
•
low-ip-address – Specifies the lowest range for
IP address assignment
•
high-ip-address – Optional. Specifies the
highest range for IP address assignment
name-server Specifies the DNS server for the DHCP client. A maximum of 6
name servers can be configured. Servers are tried in the order
entered.
•
– IP address of DNS server
nat [inside|outside]
[destination|source] Defines Network Address Translation (NAT) configuration values.
These following commands are possible for NAT
•
ip nat [inside|outside] destination static
[tcp|udp] {} – Sets the
parameters for translation for inside destination
•
ip nat [inside|outside] destination static
{}– Sets the parameters
for translation for inside destination
•
inside – Indicates inside address translation
•
outside – Indicates outside address translation
•
destination – Indicates destination address translation
•
static – Specifies local -> global address mapping
•
– The local IP address
•
– Specifies the outside local port number
•
[tcp|udp] – Specifies the protocol
•
– Specifies the outside global IP
address to translate to
•
– Optional. Specifies the outside port.
Value in the range 1 to 65535
•
ip nat [inside|outside] source list interface
[|vlan <1-4094>] overload – Sets the
parameters for translation for inside sources
•
inside – Indicates inside address translation
•
outside – Indicates outside address translation
•
source – Indicates source address translation
•
list – Specifies the ACL name
that describes local addresses
•
interface [|vlan <1-4094>] – The
interface to apply address translation to. Specify an
interface name , or use a VLAN ID
<1-4094>
•
overload – Over loads the NAT address translation
•
ip nat [inside|outside] source static
– Sets the parameters for translation for inside
sources
•
inside – Indicates inside address translation
•
outside – Indicates outside address translation
•
source – Indicates source address translation
•
static – Specifies local -> global address mapping
•
– The static global IP address to
map from
•
– The local IP address to map to