Brocade Communications Systems RFS6000 - Manual (Page 698)

696 Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide
53-1001931-01
Wireless configuration commands
20
Example
RFController(config-wireless)#wlan 25 accounting syslog
RFController(config-wireless)#
RFController(config-wireless)#wlan 25 answer-bcast-ess
RFController(config-wireless)#
RFController(config-wireless)#wlan 25 authentication-type kerberos
RFController(config-wireless)#
RFController(config-wireless)#wlan 25 description "TestWLAN"
vlan [<1-4094>|
]
{limit <0-8192>} Sets the VLAN assignment of this WLAN. This command starts a
new VLAN assignment for a WLAN index. All prior VLAN settings
are erased.
•
[<1-4094>|] –Establishes the VLAN range list. It
can be either a single index, a list (1,3,7) or a range (3-7).
•
limit <0 -8192> – Sets user limits on VLANs for this
WLAN.
wep128 [key|phrase|
wep-default-key] Configures WEP128 parameters.
•
key <1-4> [ascii|hex] – Configures pre-shared hex keys.
•
ascii [0 |1 |] – Sets keys as ascii
characters (5 characters for wep64, 13 for wep128).
•
hex [0 |1 |] – Sets keys as
hexadecimal characters (10 characters for wep64, 26
for wep128).
•
0 – Password is specified unencrypted.
•
2 – Password is encrypted with
password-encryption secret.
•
– Key (10 hex or 5 ascii characters for
wep64, 26 hex or 13 ascii characters for wep128).
•
phrase – Specifies a passphrase from which keys
are to be derived.
•
– Sets the passphrase (between 4 and 32
characters).
•
wep-default-key <1-4> – Defines the key index used for
transmission from AP to Client.
wep64 [key|phrase|
wep-default-key] Configures WEP64 parameters.
•
key <1-4> [ascii|hex] – Configures pre-shared hex keys.
•
ascii [0 |1 |] – Sets keys as ascii
characters (5 characters for wep64, 13 for wep128).
•
hex [0 |1 |] – Sets keys as
hexadecimal characters (10 characters for wep64, 26
for wep128).
•
0 – Password is specified unencrypted.
•
2 – Password is encrypted with
password-encryption secret.
•
– Key (10 hex or 5 ascii characters for
wep64, 26 hex or 13 ascii characters for wep128).
•
phrase – Specifies a passphrase from which keys
are to be derived.
•
– Sets the passphrase (between 4 and 32
characters).
•
wep-default-key <1-4> – Defines the key index used for
transmission from AP to Client.