Brocade Communications Systems RFS6000 - Manual (Page 491)

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 489
53-1001931-01
MAC Extended ACL config commands
16
deny
MAC Extended ACL config commands
Specifies packets to reject
NOTE
Use a decimal value representation of ethertypes to implement a
permit/deny/mark
designation
for a packet. The command set for Extended MAC ACLs provide the hexadecimal values for each
listed ethertype. The controller supports all ethertypes. Use the decimal equivalent of the ethertype
listed for any other ethertype.
Supported in the following platforms:
• Mobility RFS4000 Controller
• Mobility RFS6000 Controller
• Mobility RFS7000 Controller
Syntax
deny [|any|host ] [|any|
host ] {[dot1p|rule-precedence|type|vlan]}
deny [|any|host ] [|any|
host ] dot1p <0-7> {rule-precedence|type}
deny [|any|host ] [|any|
host ] rule-precedence <1-5000>
deny [|any|host ] [|any|
host ] type [8021p|<1-65535>|aarp|appletalk|apr|ip|
ipv6|ipx|rarp|wisp] {rule-precedence }
deny [|any|host ] [|any|
host ] vlan <1-4094> {rule-precedence|type}