Rockwell Automation 1771-QI,D17716.5.126 PLASTIC MOLD.MODULE - Manual (Page 99)

3–23 Status Word/Bit Descriptions
Publication 1771-6.5.126 – March 1998
SYS
Word Bit Description
SYS21 Status of Profile Execution Y 21
B00-03 RFU
B04 SYS21.B04 for QI(A) SYSB21.B04 for QI(B)
= 0 Normal
= 1 Injection Profile in Progress
The module sets this bit when it starts the profile.
Important: This bit remains set independent of injection suspensions.
The module resets this bit when:
S it completes the profile, or
S it receives a new action execution command that terminates the profile
B05 = 0 Normal
= 1 Pack Profile in Progress
The module sets this bit when it starts the profile.
The module resets this bit when:
S it completes the profile, or
S it receives a new action execution command that terminates the profile
B06 = 0 Normal
= 1 Hold Profile in Progress
The module sets this bit when it starts the profile.
The module resets this bit when:
S it completes the profile, or
S it receives a new action execution command that terminates the profile
The module does not leave this bit set when holding outputs to HDC33–36 at completion of the hold profile.
B07 = 0 Normal
= 1 Pre-decompression Movement in Progress
The module sets this bit when it starts the movement.
The module resets this bit when:
S it completes the movement, or
S it receives a new action execution command that terminates the movement
Module does not leave this bit set when holding outputs to PRC33–36 at completion of Pre-decompression movement.
B08 = 0 Normal
= 1 Plastication Profile in Progress
The module sets this bit when it starts the profile.
The module resets this bit when:
S it completes the profile, or
S it receives a new action execution command that terminates the profile
Module does not leave this bit set when holding outputs to PLC33–36 at completion of the plastication profile.
B09 = 0 Normal
= 1 Post-decompression Movement in Progress
The module sets this bit when it starts the movement.
The module resets this bit when:
S it completes the movement, or
S it receives a new action execution command that terminates the movement
Module does not leave this bit set when holding outputs to PSC33–36 at completion of Post-decompression movement
B10-15 RFU
SYS22 Status of End of Profile Set-Output Execution
B00-03 RFU
B04 = 0 Normal
= 1 End of Injection Profile Set-Output in Progress
The module sets this bit when holding its outputs to INC33–36 after completion of the profile.
The module resets this bit when it receives any new action execution command bit.
B05 RFU