Rockwell Automation 1771-QI,D17716.5.126 PLASTIC MOLD.MODULE - Manual (Page 3)

Preface
Publication 1771-6.5.126 – March 1998
Preface
Read this preface to familiarize yourself with the manual.
This preface covers the following topics:
•
the purpose of this manual
•
Related Publications
•
Terms
•
Allen-Bradley support
This manual provides reference information for the 1771-QI Plastic
Molding Module. It provides lists of words, bits, addresses, and
error codes needed for all applications. It also describes procedures
you use to calibrate the module. The contents include:
Chapter Title Contents
1
Abbreviated Command
and Status Blocks A summary list of command and status block words with
Pro-Set addresses used by the QDC module.
2
Word/Bit Descriptions
for Command Blocks A detailed list of command block words with word/bit
descriptions.
3
Word/Bit Descriptions
for Status Blocks A detailed list of status block words with word/bit
descriptions.
4 Programming
Error Codes A list of all possible error codes that could be presented
when you enter invalid data in command blocks.
5 Specifications Provides physical, electrical, environmental, and
functional specifications for the QDC module.
6 Calibration Instructions Provides procedures for calibrating the QDC module.
The 1771-QI module is similar the 1771-QDC module configured
for Inject Mode, but with additional co-injection capabilities.
We recommend that you use the following publications:
For Read This Document Pub Number
Installing your QI module to control inject operations
Plastic Molding Module User Manual 1771-QDC
Inject Mode Operation 1771-6.5.85
Selecting instructions and organizing memory when writing ladder
logic to run your machine 1785 PLC-5 Programmable Controller
Instruction Set Reference 1785-6.1
Installing Pro-Set 700 injection molding software Pro-Set 700 Installation Instructions 6500-5.4
Installing your Pro-Set 700 operator interface Pro-Set 700 Operator Interface Installation Manual 6500-6.2.1
Customizing Pro-Set 700 software for your application
Pro-Set 700 Software Release 2.1 Reference Mnl
6500-6.4.3
Setting up your molding machine for use with Pro-Set 700 software Pro-Set 700 Software Release 2.1 User Manual 6500-6.5.18
Using co-injection software Pro-Set 700 Co-injection Software User Manual 6500-6.5.19
Inputting injection molding system setpoints and actuals Pro-Set 700 Systems Jobsetting Guide 6500-6.9.3
Installing modules for co–injection applications Installing Co-injection and Plastic Molding Modules 6500-10.1
A complete listing of current Allen-Bradley documentation Allen-Bradley Publication Index SD499
Purpose of this Manual
Related Publications