F code method – Xerox WorkCentre M24-3946 User Manual
Page 83
4.3 Transmitting Documents Through a Remote Relay Station (Remote Relay Broadcast)
59
B
roadc
ast Sen
d
4
4.3.3
F Code Method
In the F Code method, you can do remote Relay Broadcast Send by doing the
following operations.
When doing remote Relay Broadcast Send using this machine as the initiating
station, check the F Code and the necessary passwords for the first relay station.
When doing remote Relay Broadcast Send using this machine as the first relay
station, transmit the F Code (sub-address) and the necessary passwords to the
initiating station, and check the F Code for the second relay station.
When doing remote Relay Broadcast Send using this machine as the second
relay station, transmit the F Code and the necessary passwords to the first relay
station.
It is necessary to assign the first relay station and second relay station Address
Numbers in advance, as shown below.
Station one and station two and equipment on which the Relay Broadcast Send function and the F
Code method are installed are targeted when using the F Code method for remote Relay Broadcast
Send.
Where
What is required
First relay station
●
Assign the initiating station either an Address Number from
001 to 500 (when the specification method for the initiating
station is 3 digits in F Code) or 001 to 099 (when the spec-
ification method for the initiating station is 2 digits in F
Code). Then, set Relay Station Setup of the Address Num-
ber to On.
●
Assign the second relay station either an Address Number
from 001 to 500 (when the specification method for the ini-
tiating station is 3 digits in F Code) or 001 to 099 (when the
specification method for the initiating station is 2 digits in F
Code).
●
Assign the last two digits of the Address Number for the
first relay station that has been assigned to the second
station as the relay station ID.
●
Assign the Address Number for the destination station
that has been assigned to the second relay station as the
Broadcast Recipients.
Second relay station
●
Assign the same number for the first relay station as the
Address Number of the initiating station that has been
assigned to the first relay station. Then, set Relay Station
Setup of the Address Number to On.
●
Assign the destination either an Address Number from 001
to 500 (when the specification method for the initiating sta-
tion is 3 digits in F Code) or 001 to 099 (when the specifi-
cation method for the initiating station is 2 digits in F Code).