Xerox WorkCentre M24-3946 - Manual (Page 239)

10.7 Activity Report
215
10
R
e
ports/
L
is
ts
Item Description
No. The serial numbers for transmissions is shown.
Doc. Job numbers that the machine automatically assigned to
documents when the documents were received.
Remote Station Information on recipient to which transmission is made is
recorded in the following order of priority.
■
Transmitting (speed dialing)
Recipient
Remote terminal name
G3 ID (including spaces)
Tel No.
Communication mode EC (or G3, SG3)
■
Transmitting (when all digits are dialed)
Remote terminal name
G3 ID (including spaces)
Tel No.
Communication mode EC (or G3, SG3)
■
Receiving
Remote terminal name
G3 ID (including spaces)
Communication mode EC (or G3, SG3)
You can set the number of character digits displayed for the recipi-
ent. For details on setting up, see “9.8.4 Reports” (P. 184). The
factory set default displays the first 40 digits.
Start Time The date and time that the communication began are shown.
In Batch Send, the start time of the transmission for each
document is recorded.
Duration The communication length is indicated. In Batch Send, the
length of time taken for a transmission for each document is
recorded.
Pages “ - ” is indicated when the number of pages is 0.
■
Transmitting
The number printed on the left side of the slash “/” indicates
the number of pages that were successfully transmitted. The
number printed on the right side of the slash “/” indicates the
number of total pages.In Manual Send, the number of total
pages is not shown.
■
Receiving/Polling
The number of pages that the machine successfully received
is shown.
Mode The mode used for the communication is shown here.
There are three modes; G3, EC and SG3 (Super G3). (This
field is blank if a mode other than these was used.)
1
2
3
4
5
1
2
3
4
1
2
3