Xerox WorkCentre M24-3946 - Manual (Page 78)

4.3 Transmitting Documents Through a Remote Relay Station (Remote Relay Broadcast)
54
4
B
roadc
ast Sen
d
4.3.1 Fax Signal Method
Before using the fax signal method, program the initiating station, first relay sta-
tion and second relay station in Address Number.
For details on how to register Address Numbers, see “9.3 Setting an Address Number” (P. 150).
Procedure
1
Load documents.
“2.2 Loading Documents” (P. 14)
Where What is required
Initiating
station
● Assign the first relay station to an Address Number (001 to 500) to set up
the relay broadcast send feature.
• Program the last two digits of the Address Number of the initiating station
(which is already programmed at a relay station) as a relay station ID for
the relay broadcast send operation.
• Program the Address Number of the second relay station (which is
already programmed at the first relay station) as a relay broadcast
receiver.
First relay
station
● Assign the initiating station to an Address Number from 001 to 099, and set
Relay Station Setup of the Address Number to On.
● Assign the second relay station to an Address Number from 001 to 099.
• Program the two last digits of the Address Number of the first relay station
(which is already programmed at the second relay station) as a relay sta-
tion ID for the Relay Broadcast Send operation.
• Program the Address Numbers of the destinations (which are already
programmed at the second relay station) as broadcast receivers.
Second
relay
station
● Assign the first relay station to the same Address Number as that of the ini-
tiating station programmed at the first relay station, and set Relay Station
Setup of the Address Number to On.
● Program the destinations to Address Numbers between 001 and 500.
● Destinations of Address Number 100 or above can be programmed into a
group.