Xerox WorkCentre M24-3946 - Manual (Page 243)

10.8 Transmission Report
219
10
R
e
ports/
L
is
ts
Mode The mode used for the communication is shown here.
There are three modes; G3, EC and SG3 (Super G3). (This
field is blank if a mode other than these was used.)
Contents The information about the communication is indicated here.
Refer to the Note field at the bottom of the report for a list of
abbreviations and their definitions.
■
Transmitting
Remote service Redial Mailbox XXX Broadcast/
Multi-Poll Polling Relay Broadcast Relay Broadcast
Fax forwarding box XXX
■
Receiving
Mailbox XXX Polling Relay broadcast request
Receiving line box XXX Transmitting telephone number
box XXX
● XXX indicates the Mailbox number.
● Relay Broadcast is printed when Relay Broadcast and Relay
Broadcast Assignment are both specified at transmission.
Status The result of the operation is indicated here.
Normal .............The operation ended normally.
Busy .................The recipient is busy or did not answer.
Auto resend .....The document is being resent and the set
resend times has not been exceeded.
Terminated.......The communication was terminated.
Recipient check required .. An error caused by the recipient
or the line during communication.
Retransmission required ... Document must be retransmitted.
Re-reception
required ....... Document must be received
again.
Cable check required ........ Check that the line is properly
connected.
XXX-XXX ........Error code
For details on lines, see “1.3 Telephone Line Connectors” (P. 4)
and for details on XXX-XXX (error code), see “11.2 Error Code
List” (P. 234).
Total number of pages All received pages are recorded.
Item Description
1 2 3 4
5 6 7
8
1 2 3
4 5