Xerox WorkCentre M24-3946 - Manual (Page 163)

Us
in
g
Ad
di
ti
on
a
l F
e
at
ur
e
s
139
8
8.17
Transmitting with F Code
(F Code Transmitting)
Transmitting with F Code, the use of sub-addresses was standardized in T.30 (a
transmission regulation) created by ITU-T, the transmission procedure set by a
telecommunication advisory committee.
Various functions can be used with other companies that use F Code through
transmission between equipment with the F Code function.
● It is necessary to check the F Code of the other party’s machine in advance to use F Code method.
● You can set the F Code and password for each Address Number. For details on registering Address
Numbers, see “9.3 Setting an Address Number” (P. 150).
8.17.1 About F Code and Passwords
When using F Code transmission, use the F Code and password.
The F Code, called a sub-address by other companies, must be registered
(entered).
Set the password whenever it is necessary.
8.17.2 Functions Used with F Code Transmis-
sion
You can use the following functions with F Code transmissions.
■
Relay Broadcast Send/Remote Relay Broadcast Send
When this machine is an initiating station:
You can do Relay Broadcast Send if the F Code that has been set for the relay
station and the necessary passwords are registered on this machine.
When this machine is a relay station:
You can do Relay Broadcast Send if the F Code that has been set for the initiat-
ing station and the necessary passwords are registered on this machine.
For details about Relay Broadcast Send see “4.2.4 F Code Method” (P. 49), and for details about
remote Relay Broadcast Send, see “4.3.3 F Code Method” (P. 59).
■
Send to Mailbox
You can send documents to a mailbox by setting the F Code and the necessary
passwords when the other party's mailbox is set.
For details about sending to a mailbox, see “8.14.3 Send to Mailbox (F Code Method)” (P. 122).