Xerox Color 550-560-570 Printer con Xerox CX Print Server powered by Creo-16023 - Manual (Page 88)

19. Press Close until the Adjust Fold Position screen appears.
20. Select the tray to assign the set type (the tray in which you loaded the paper in Step
1), and press Change Settings.
21. Select the adjusted fold position type, and press Save.
Single Fold Position Adjustment
1. Select Single Fold, and press Change Settings.
2. Specify Sheets to be folded, and press Sample Printout.
3. Select the tray and press the Start button.
4. Press Close.
5. Check the output sample printout, and measure the offset amount.
6. Select Long at Left or Long at Right.
7. Enter the measurement value you obtained in Step 5 in Values A Before Adjustment
field by touching the up/down arrow buttons; refer to the screen above.
8. Press Adjust.
9. Press Sample Printout again to print an output sample printout, and check the
adjustment results.
10. Make adjustments again if necessary. (Steps 6 - 8.)
11. Press Save.
Booklet Position Adjustment
1. Select Booklet, and press Change Settings.
2. Press Sample Printout.
3. Select the tray, select 2-Sheet Stack, and press the Start button.
4. An output sample is printed.
5. Select the tray, select 15-Sheet Stack, and press the Start button.
6. Press Close.
7. Check the output sample, and measure the position offset amount for 2-sheet stack
and 15-sheet stack.
8. Press Booklet Fold State (2 Sheets).
9. Select the state of the fold and staple position of the output paper, and enter the
2-sheet stack offset amount you measured in Step 6 in Values A.
10. Press Save.
Note
The values between 2-sheet stack and 15-sheet stack are adjusted automatically.
Note
When you want to specify the number of sheets separately, use the set
Variable-Sheet Booklet option to make the proper selections.
Xerox ® Color 550/560/570 Printer 8-4
System Administrator Guide
Image Registration Setups