Xerox Color 550-560-570 Printer con Xerox CX Print Server powered by Creo-16023 - Manual (Page 166)

Installing Custom Services Software
1. In CentreWare Internet Services, click Properties > Services > Machine Software
> Manual Upgrade.
2. Under Manual Upgrade, click Browse, then locate the InstallCustomServices.dlm
file for the custom application you want to install.
3. When you locate the file, click Open, then click Install Software.
Enabling Extensible Service Registration
1. In CentreWare Internet Services, clickProperties > General Setup > Extensible
Service Setup.
Note
If Extensible Service Setup does not display, the custom services software file was
not installed correctly or the installation failed.
2. Under Setup, click Edit.
3. Select the services you want to enable and click Apply.
4. Under Enable Extensible Services, select Export password to Extensible Services.
5. Under Browser Settings, select Enable the Extensible Services Browser if necessary.
6. Select Verify server certificates if necessary.
7. To configure proxy settings, under Proxy Server select Use Proxy Server.
8. Next to Proxy Setup, select Same Proxy for All Protocols to use the same settings
for HTTP and HTTPS. Select Different Proxy for Each Protocol to enter separate
server addresses for HTTP and HTTPS.
9. Type your HTTP and HTTPS server address and port number.
10. Click Apply.
Auxiliary Interface Kit
An Auxiliary Interface Kit, or a Foreign Device Interface kit, is a third-party access and
accounting device such as a coin operated printer accessory or a card reader that can
be attached to the printer. Installation instructions are included with the Foreign Device
Interface Kit. After the kit is installed, you must enable and configure the device at the
control panel.
Xerox ® Color 550/560/570 Printer 16-2
System Administrator Guide
Customization and Expansion