Xerox DocuColor 240-250 con built-in Fiery controller-16150 - Manual

Customer Release Notes
Fiery Network Controller for DocuColor 240/250,
version 1.1
Part Number: 45054621
10 March 2006
Copyright 2006 © Electronics for Imaging, Inc.
This document contains information about the Fiery Network Controller for
DocuColor 240/250 version 1.1. Before using the Fiery Network Controller for
DocuColor 240/250 with version 1.1, make copies of these
Customer Release Notes and
the Quick Connect Guide and distribute them to all users.
N OTE : This document uses the term “Fiery” to refer to the Fiery Network Controller for
DocuColor 240/250. The term “copier” is used to refer to the DocuColor 240/250 copier.
Before printing to the Fiery, make sure that system software version 1.1 is installed on the
Fiery. To determine this, print a copy of the Configuration page from the copier control panel
as follows:
1 Press the Machine Status button.
2 Touch the Billing Meter/Print Report tab on the touch screen.
3 Touch the Print Report/List option, and then the Network Controller Jobs Report option.
4 Select the System Settings List option.
5 Press the green Start button to print the Configuration page.
You must also install user software version 1.1 onto client computers. For instructions,
see
Printing from Windows and Printing from Mac OS .
User
documentation User documentation available online
For user documentation in all supported languages, including the Customer User Addendum ,
see the following website:
http://services.efi.com/support/vfigs/9019710383/
System software System software installation
If you install system software from a client computer over the network, and the installation
fails because of connection timeout, exit any applications and disable any virus protection
software or pop-up blocker on the client computer.
After installing, upgrading, or reinstalling software
After installing , upgrading, or reinstalling your system software, you must reboot the Fiery.