Xerox Color 550-560-570 Printer con Xerox CX Print Server powered by Creo-16023 - Manual (Page 61)

5. Type the Connection Time-Out (1-300 seconds).
6. Click Apply to accept the changes or Undo to retain the previous settings.
Setting Up Authentication for a USB Smartcard Reader System
To use the printer with a card reader system other than Xerox Secure Access, you must
order and install the Xerox Common Access Card Enablement Kit. The kit includes
hardware, software, and instructions for connecting and configuring your card reader
system.
Before you begin:
• Install the USB Enablement Kit
• Install a Kerberos authentication server and configure with user accounts.
• Connect your card reader to the printer.
Configure Network Authentication Settings
1. Configure network authentication. For details, see Network Authentication.
2. Configure Kerberos server settings. For details, see Configuring Authentication Server
Settings for Kerberos.
Enable SmartCard Settings
1. At the printer control panel, press the Machine Status button and touch the Machine
Informationtab.
2. Touch Authentication / Security Settings > Authentication > User Details Setup
> Use of SmartCard.
3. Touch Change Settings.
4. Touch Enabled.
5. Under Jobs Validated by Card select Copy, Print, or Fax/Scan, and touch Save.
Configure SmartCard Link Mode Settings
1. At the printer control panel, press the Machine Status button and touch the Machine
Information tab.
2. Touch Authentication / Security Settings > Authentication > User Details Setup
> SmartCard Link Mode.
3. Touch Change Settings.
4. Touch No Passcode Required, and touchSave.
Set the SmartCard Certificate Verification Mode
For additional security, you can set the printer to validate a user's SmartCard against
certificates stored on the printer.
6-7 Xerox ® Color 550/560/570 Printer
System Administrator Guide
Security