Physio-Control LIFEPAK 15 - Manual (Page 201)

POWER ADAPTER
9
©2007-2013 Physio-Control, Inc. LIFEPAK 15 Monitor/Defibrillator Operating Instructions
9-5
Using the Power Adapter
This section provides information about operating the AC and DC power adapters that can be used
with the LIFEPAK 15 monitor/defibrillator.
AC Power Adapter Operation
To use the AC Power Adapter:
1. Connect the AC power cord to the power adapter and a grounded AC outlet.
2. Verify that the green LED strip illuminates.
3. Connect the power adapter output cable to the power adapter.
4. Connect the green end of the power adapter output cable to the auxiliary power connector on the
back of the monitor/defibrillator.
5. Verify that the AUXILIARY POWER LED on the defibrillator is illuminated.
6. If at least one battery is installed in the device, verify that the BATTERY CHARGING indicator is
illuminated or flashing. Indicator behaviors are shown in Table 9-1.
7. Press the monitor/defibrillator ON button.
Figure 9-2 AC Power Adapter with LIFEPAK 15 Monitor/Defibrillator
Table 9-1 Battery Charging Indicator Behaviors
INDICATOR DESCRIPTION
Steady green Installed batteries are fully charged.
Flashing green One or both installed batteries are being charged.
Off No batteries are installed, or a battery is unable to be charged.
Power Adapter
Output Cable
LED Strip