Preparing the monitor for transmission – Physio-Control LIFEPAK 15 User Manual
Page 182
8-4
LIFEPAK 15 Monitor/Defibrillator Operating Instructions
Preparing the Monitor for Transmission
Preparing the Monitor for Transmission
Before you can transmit using a wireless or direct connection, you must define transmission sites
and output ports in the LIFEPAK 15 monitor Setup mode.
For each transmission site, select an output port:
• For wireless transmission, set
OUTPUT PORT
to
BLUETOOTH WIRELESS
.
• For a direct connection, set
OUTPUT PORT
to
DIRECT CONNECT
.
• Set
OUTPUT PORT
to
BOTH
if you normally transmit using a Bluetooth connection but you need a
direct cable backup. (If you set
OUTPUT PORT
to
BOTH
, make sure the Bluetooth LED is not
illuminated before you attempt to transmit using a direct connection. The device will not
transmit using the direct connection when a wireless connection is available.)
For more information, see the LIFEPAK 15 Monitor/Defibrillator Setup Options provided with your
device.