Physio-Control LIFEPAK 15 - Manual (Page 189)

DATA TRANSMISSION
8
©2007-2013 Physio-Control, Inc. LIFEPAK 15 Monitor/Defibrillator Operating Instructions
8-11
To establish a direct connection:
1. Position the PC or LIFENET Gateway within reach of the LIFEPAK 15 monitor.
Note: If you are storing a LIFENET Gateway (modem) in the carrying case, only store the
modem in the side pouch. Do not store LIFENET Gateways in the back pouch.
2. Configure a COM port on the PC for incoming data.
3. Connect the cable to the system connector on the monitor and to the PC.
4. If using CODE-STAT or DT EXPRESS software, open the download wizard on the PC and select
the LIFEPAK 15 monitor.
After you establish a direct connection, you are ready to transmit patient data. Proceed to
"Transmitting Reports" on page 8-12.