NEC PD78F9488 - Manual (Page 323)

CHAPTER 19 FLASH MEMORY VERSION
User’s Manual U15331EJ4V1UD
323
If Flashpro III/Flashpro IV is used as a dedicated flash programmer, the following signals are generated for the
µPD78F9488 and 78F9489. For details, refer to the manual of Flashpro III/Flashpro IV.
Table 19-3. Pin Connection List
Signal Name I/O Pin Function Pin Name 3-Wire Serial I/O 3-Wire Serial I/O
with Handshake
UART
VPP1 Output Write voltage V
PP
VPP2 − − − Ч Ч Ч
VDD I/O V
DD
voltage generation/
voltage monitoring
V
DD
Note Note Note
GND − Ground V
SS
CLK Output Clock output X1
RESET Output Reset signal RESET
SI Input Receive signal SO20/TxD20
SO Output Transmit signal SI20/RxD20
SCK Output Transfer clock SCK20 ×
HS Input Handshake signal P11 (HS) Ч Ч
Note V
DD
voltage must be supplied before programming is started.
Remark :
Pin must be connected.
: If the signal is supplied on the target board, pin does not need to be connected.
× : Pin does not need to be connected.