Motorola Series Switch WS5100 - Manual (Page 69)

Switch Information 3-25
3. Refer to the Cluster Configuration field to enable and define the configuration for automatic cluster
file updates.
4. Refer to the Firmware field to enable and define the configuration for automatic firmware updates. If
enabled, the located (updated) switch firmware will be used with the switch the next time the switch
boots
5. Click the Apply button to save the changes to the configuration.
6. Click the Revert button to revert back to the last saved configuration.
File Name (With
Path) Provide the complete and accurate path to the location of the configuration files on the
server. This path must be accurate to ensure the most recent file is retrieved.
Protocol Use the Protocol drop-down menu to specify the FTP, TFTP, HTTP, SFTP or resident
switch FLASH medium used for the file update from the server. FLASH is the default
setting.
Password Enter the password required to access the server.
Enable Select the Enable checkbox to allow an automatic cluster file update when a new (updated)
file is detected (upon the boot of the switch) at the specified IP address.
IP Address Define the IP address of the server where the cluster files reside. If a new version is
detected when the switch is booted it will be uploaded to the switch and used upon the next
boot of the switch.
User ID Enter the User ID required to access the FTP or TFTP server.
File Name (With
Path) Provide the complete and accurate path to the location of the cluster files on the server. This
path must be accurate to ensure the most recent file is retrieved.
Protocol Use the Protocol drop-down menu to specify the FTP, TFTP, HTTP, SFTP or resident
switch FLASH medium used for the file update from the server. FLASH is the default
setting.
Password Enter the password required to access the server.
Enable Select the Enable checkbox to allow an automatic firmware update when a new (updated)
version is detected (upon the boot of the switch) at the specified IP address.
IP Address Define the IP address of the server where the firmware files reside. If a new version is
detected when the switch is booted it will be uploaded to the switch and used upon the next
boot of the switch.
User ID Enter the User ID required to access the FTP or TFTP server.
File Name (With
Path) Provide the complete and accurate path to the location of the firmware files on the server.
This path must be accurate to ensure the file is retrieved.
Protocol Use the Protocol drop-down menu to specify the FTP, TFTP, HTTP, SFTP or resident
switch FLASH medium used for the file update from the server. FLASH is the default
setting.
Password Enter the password required to access the server.
Version Provide the target firmware version to ensure the switch is upgrading to the intended
baseline.