beautypg.com

2 enabling global settings for the failover image – Motorola Series Switch WS5100 User Manual

Page 66

background image

3-22 WS5100 Series Switch System Reference Guide

2. Click the

Edit

button.

The

Firmware

screen displays the current firmware version and whether this version is used for the next

reboot.

3. Select the checkbox to use this version on the next boot of the switch.

4. To edit the secondary image, select the secondary image, click the

Edit

button and select the

Use this

firmware on next reboot

checkbox.

This firmware version will now be the file initiated after the next reboot of the switch.

5. Refer to the

Status

field for the current state of the requests made from the applet. Requests are any

“SET/GET” operation from the applet. The Status field displays error messages if something goes wrong
in the transaction between the applet and the switch.

6. Click the

OK

button to commit the changes made and exit the screen.

3.4.2 Enabling Global Settings for the Failover Image

Use the

Global Settings

screen to specify a firmware version for use with the failover image.

1. Select an image from the table in the Firmware screen.

2. Click the

Global Settings

button.

3. Select the

Enable Image Failover

checkbox to load an alternative firmware version if the WLAN

module fails to load the selected version successfully after 2 reboot attempts.

4. Refer to the

Status

field for the current state of the requests made from the applet. Requests are any

“SET/GET” operation from the applet. The Status field displays error messages if something goes wrong
in the transaction between the applet and the switch.

5. Click

OK

to save and add the changes to the running configuration and close the dialog.