2 viewing unadopted access ports, 2 viewing unadopted access ports -93 – Motorola Series Switch WS5100 User Manual
Page 167
Network Setup
4-93
2. Click the
Adopted AP
tab.
3. Refer to the
Adopted AP
screen for the following information:
4. Click the
Export
button to export the contents of the table to a Comma Separated Values file (CSV).
4.9.2 Viewing Unadopted Access Ports
Use the
Unadopted AP
tab for gathering device hardware address and software version information for the
access port.
To view existing Radio Configuration information:
MAC Address
Displays the radio's first MAC address when it is adopted by the switch.
Model
Displays s the Model Number of the access port.
Serial
Displays the serial number of the access port, and is used for management purposes by the
switch. It is read-only and cannot be modified.
HW Version
Displays the Hardware Version of the access port. This information can be helpful when
troubleshooting problems with the access port.
IP Address
Displays the IP address of the adopted access port.
Bootloader
The Bootloader value displays the software version the access port boots from. This
information can be helpful when troubleshooting problems.
WISP Version
Displays the version of the interface protocol between the access port and the switch. This
information can be helpful when troubleshooting problems with the access port.
Fw Version
Displays the firmware version on the access port at run time. Use this information to assess
whether the software requires an upgrade for better compatibility with the Switch.
Radio Indices
Displays the indices of the radios belonging to the selected access port. These indices are
equivalent to a numerical device recognition identifier (index) for the radio.