3 attaching an acl, 1 adding a new acl configuration, 3 attaching an acl -24 – Motorola Series Switch WS5100 User Manual
Page 248: Attaching an acl
6-24 WS5100 Series Switch System Reference Guide
6.5.3 Attaching an ACL
Use the
Attach-L2/L3
screen to view and assign the ACL to a physical interface or VLAN on the switch.
To attach an interface:
1. Select
Security
>
ACLs
from the main menu tree.
2. Click the
Attach-L2/L3
tab.
3. Refer to the following information as displayed within the Attach tab:
4. Select an interface and click on
Edit
to modify the ACL interface, IP ACL and MAC ACL values.
5. Select an interface and click the
Delete
button to delete the interface configuration from the switch.
6. Click on
Add
button to add an physical or VLAN interface to the switch. For more information, see Adding
a New ACL Configuration on page 6-24.
6.5.3.1 Adding a New ACL Configuration
After creating an ACL, it can be applied to one or more interfaces. On a Layer 3 interface it can be applied in
either an outbound or inbound direction, and only in inbound direction on a Layer 2 interface. To add an ACL
interface to the switch:
1. Select
Security
>
ACLs
from the main menu tree.
Interface
The interface to which the switch is configured. It can be one of the following:
• eth1
• eth2
• vlan1 (or any additional VLANs that have been created)
• tunnel n (where n equals the name(s) of those tunnels created thus far).
IP ACL
Displays the IP ACL configured as the inbound IP for the layer 2 or layer 3 interface.
MAC ACL
Displays the MAC ACL to be configured as the MAC IP for the layer 2 interface.