Motorola Series Switch WS5100 - Manual (Page 137)

Network Setup 4-63
4. Refer to the Information field for the following information:
5. Refer to the Traffic field for the following information:
6. Refer to the RF Status field for the following information:
7. Refer to the Errors field for the following information:
8. Refer to the Status field for the current state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the switch.
9. Click Cancel to close the dialog without committing updates to the running configuration.
MAC Address Displays the Hardware or Media Access Control (MAC) address for the MU. This address is
hard-coded at the factory and cannot be modified.
BSS Address Displays the MU’s BSSID.
IP Address Displays the current IP address for the MU.
Voice Displays whether the MU is a voice capable device. Traffic from voice enabled MUs is
handled differently than traffic from MUs without this capability.
WLAN Displays the name of the WLAN the MU is currently associated with.
WMM Displays WMM usage status for the MU, including the Access Category currently in use. Use
this information to assess whether the MU is using the correct WMM settings in relation to
the operation of the switch.
Pkts per second Displays the average total packets per second received by the selected MU. The Rx column
displays the average total packets per second received on the selected MU. The Tx column
displays the average total packets per second sent on the selected MU.
Throughput Displays the average throughput in Mbps between the selected MU and the access port. The
Rx column displays the average throughput in Mbps for packets received on the selected MU
from the access port. The Tx column displays the average throughput for packets sent on the
selected MU from the access port.
Avg. Bit Speed Displays the average bit speed in Mbps on the selected MU. This includes all packets sent
and received.
% Non-unicast pkts Displays the percentage of the total packets for the selected MU that are non-unicast
packets. Non-unicast packets include broadcast and multicast packets.
Avg MU Signal Displays the RF signal strength in dBm for the selected MU.
Avg MU Noise Displays the RF noise for the selected MU.
Avg MU SNR Displays the Signal to Noise Ratio (SNR) for the selected MU. The Signal to Noise Ratio is
an indication of overall RF performance on your wireless network.
Avg Num of Retries Displays the average number of retries for the selected MU. Use this information to assess
potential performance issues.
% Gave Up Pkts Displays the percentage of packets the switch gave up on for the selected MU.
% of Undecryptable
Pkts Displays the percentage of undecryptable packets (packets that could not be processed) for
the selected MU.