Motorola Series Switch WS5100 User Manual
Page 187
Switch Services
5-17
2. Select the
Configuration
tab.
3. An ACL Id must be created before it is selectable from any of the drop-down menus. Refer to the
Access
Group
field to define the following:
4. Refer to the
Other Settings
field to define the following:
Full Access
Supply a numeric ACL ID to enable the supplied ACL ID full access.
Only Control Queries
Supply a numeric ACL ID to enable the supplied ID only control query access to SNTP
resources.
Server and Query
Access
Enter a numeric ACL ID to enable the supplied ACL ID Server and Query access to SNTP
resources.
Only Server Access
Define a numeric ACL ID to enable the supplied ACL ID only server access to SNTP resources.
Authenticate Time
Sources
Select this checkbox to ensure a credential authentication step is included between the
SNTP server and the switch. When this checkbox is selected, the Apply and Revert buttons
become enabled to save or cancel settings within the Other Settings field.
Act As NTP Master
Clock
When this checkbox is selected, the Apply and Revert buttons become enabled to save or
cancel settings within the Other Settings field.
Clock Stratum
Define how many hops (from 1 to 15) the switch is from a SNTP time source. The switch
automatically chooses the SNTP resource with the lowest stratum number. The SNTP
supported switch is careful to avoid synchronizing to a server that may not be accurate. Thus,
the SNTP enabled switch never synchronizes to a machine not synchronized itself. The SNTP
enabled switch compares the time reported by several sources, and does not synchronize to
a time source whose time is significantly different than others, even if its stratum is lower.
Listen to NTP
Broadcasts
Select this checkbox to allow the switch to listed over the network for SNTP broadcast
traffic. Once enabled, the switch and the SNTP broadcast server must be on the same
network.