Motorola Series Switch WS5100 - Manual (Page 246)

6-22 WS5100 Series Switch System Reference Guide
3. Click the Add button within the Associated Rules field.
4. Use the Precedence field to enter a precedence (priority) value between 1 and 5000.
The rules within an ACL will be applied to packets based on their precedence value. Rules with lower
precedence are always applied first.
5. Use the Operation drop-down menu to define a permit, deny or mark designation for the ACL. If the
action is to mark, the packet is tagged for priority.
6. Select the Logging checkbox to allow the log messages to be generated when a packet has been
forwarded, denied or marked based on the criteria specified in the access lists.
7. If mark is selected from within the Operations drop-down menu, the Attribute to mark field becomes
enabled. Select the 802.1p (0 - 7) or TOS(0 - 255) checkbox and define the attribute receiving priority
with this ACL mark designation.
8. From within the Filters field, select a Source Wildcard/Mask from the drop-down menu.
The source is the source address of the network or host in dotted decimal format. The Source-mask is the
network mask.
9. Use the Source Address field to enter the IP address from where the packets are sourced.
10.Refer to the Status field for the current state of the requests made from applet. This field displays error
messages if something goes wrong in the transaction between the applet and the switch.
11.Click OK to use the changes to the running configuration and close the dialog.
12.Click Cancel to close the dialog without committing updates to the running configuration.
NOTE: If adding an access control entry to an ACL using the switch SNMP interface,
Precedence is a required parameter.