Motorola Series Switch WS5100 - Manual (Page 144)

4-70 WS5100 Series Switch System Reference Guide
8. From within the Radio Settings field, define the Placement of the access port as either Indoors or
Outdoors .
An access port can be set for Indoors or Outdoors use depending on the model and the placement
location. Power settings and channel selection options differ based on each country's regulatory rules
and whether or not the unit is placed indoors or outdoors.
9. Select a channel for communications between the access port and its associated MUs within the
Desired Channel field.
The selection of a channel determines the available power levels. The range of legally approved
communication channels varies depending on the installation location and country. The selected channel
can be a specific channel, “Random,” or “ACS.” Random assigns each radio a random channel. ACS
(Automatic Channel Selection) allows the switch to systematically assign channels. Default is Random.
10.After first selecting a channel, select a power level in dBm for RF signal strength in the Desired Power
(dBm) field.
The optimal power level for the specified channel is best determined by a site survey prior to installation.
Available settings are determined according to the selected channel. Set a higher power level to ensure
RF coverage in WLAN environments that have more electromagnetic interference or greater distances
between the access port and MUs. Decrease the power level according to the proximity of other access
ports. Overlapping RF coverage may cause lost packets and difficulty for roaming devices trying to
engage a access port. After setting a power level, channel and placement the RF output power for the
access port is displayed in mW. Default is 20 dBm (802.11bg), 17 dBm (802.11a).
11.To configure optional rate settings, click the Rate Settings button to display a new dialogue containing
rate setting information. Instructions on configuring rate settings is described in Configuring Rate
Settings on page 4-72.
12.In most cases, the default settings for the Advanced Properties are sufficient. If needed, additional
Advanced Properties can be modified for the following:
NOTE: After setting a power level, channel and placement, the RF output power for the
access port is displays in mW.
Antenna Diversity Use the drop-down menu to configure the Antenna Diversity settings for access ports using
external antennas. Options include:
• Full Diversity: Utilizes both antennas to provide antenna diversity.
• Primary Only: Enables only the primary antenna.
• Secondary Only: Enables only the secondary antenna.
Antenna Diversity should only be enabled if the access port has two matching external
antennas. Default value is
Full Diversity .
Maximum MUs Sets the maximum number of MUs that can associate to a radio. The maximum number of
MUs that can associate to a radio is 64.
Adoption Preference
ID Displays the preference ID of the switch.The value can be set between 1 and 65535. To make
the radios preferred, the access port preference ID should be same as adoption preference
ID.
The adoption preference id is used for AP load-balancing. A switch will preferentially adopt
APs which have the same adoption preference- ID as the switch itself.