Motorola Series Switch WS5100 - Manual (Page 53)

Switch Information 3-9
3. Select a port and click the Edit button to modify the port configuration. For additional information, see
Editing the Port Configuration on page 3-9 .
3.2.1.1 Editing the Port Configuration
To modify the port configuration:
1. Select a port from the table displayed within the Configuration screen.
2. Click the Edit button.
A Port Change Warning screen displays, stating any change to the port setting could disrupt access to
the switch. Communication errors may occur even if the modification made are successful.
3. Click the OK button to continue.
Optionally select the Don’t show this message again for the rest of the session checkbox to disable
this pop-up.
4. Use the Edit screen to modify the following port configurations for the selected port.
Name Displays the current port name. By default, eth1 and eth2 are available.
MAC Address Displays the port’s MAC Address. This value is read-only, set at the factory and cannot be
modified.
Admin Status Displays whether the port is currently Up or Down.
Speed Displays the current speed of the data transmitted and received over the port.
Duplex Displays the port as either half or full duplex.