beautypg.com

6 configuring a ping, 6 configuring a ping -18, Configuring a ping – Motorola Series Switch WS5100 User Manual

Page 354

background image

8-18 WS5100 Series Switch System Reference Guide

• What kinds of message should be seen.

4. Select the

Send log message to a file

checkbox if you wish to store the log message.

Enabling this checkbox allows you to select the file location where you wish to store the log message.

5. Select the

Use SNMP V2 only

checkbox to use SNMP v2 to debug the applet.

Check whether you have access to SNMP v2 by clicking on the

Test SNMP V2 access

button.

6. Select the severity of the message that you wish to store in the log file.

The

Message Severity

section allows you to report a bug and log it as per the following severity levels:

• Fatal - loss of data or switch functionality

• Error - switch data compilation problem, could result in data loss

• Warning - potential data loss of configuration corruption

• Informational - data that may be useful in assessing a potential error

• Debug - information relevant to troubleshooting

• None - no impact.

7. Select the message when a bug is raised.

The

What Kind of message should be seen

field allows you to select a range of parameters for which

you can see a message while you debug. Place your mouse pointer over the message type check box for
the message description.

a. Click the

Advanced

button to display the entire list of message categories for when switch bugs are

raised. Select the checkboxes corresponding to the message types you would like to receive.

Each message category is enabled by default. Click the

Simple

button to minimize this area and hide

the available message categories.

b. Click the

All Messages

button to select all the message categories.

c. Click the

No Messages

button if you do not want to select any of the message categories.

8. Click the

Apply

button to save the changes you have applied within this screen.

9. Click the

Revert

button to revert back to the last saved configuration.

8.6 Configuring a Ping

The switch can verify its link with other switches and associated MUs by sending ping packets to the
associated device. Use a ping to test the connection between the switch and IP destinations you specify. For
each ping transmitted by the switch, statistics are gathered for the round-trip time (RTT) between switch and
destination. The RTT is the time in milliseconds for a ping packet to travel from the switch to its target
destination and back again. This number can vary significantly because of the random nature of packet
routings and random loads on the switch and its destination.