beautypg.com

4 attaching an acl on a wlan interface/port, 4 attaching an acl on a wlan interface/port -25, Attaching an acl on a wlan interface/port – Motorola Series Switch WS5100 User Manual

Page 249

background image

Switch Security

6-25

2. Click on the

Attach

tab.

3. Click on the

Add

button.

4. Use the

Interface

drop-down menu to select the interface to configure on the switch. Available options

include – Ethernet 1, Ethernet 2, VLAN 1 (plus those VLANs created thus far) and Tunnel n

(where n equals

the name(s) of those tunnels created thus far).

5. Use the

IP ACL

drop-down menu to select an IP ACL used as the inbound IP for the layer 2 or layer 3

interface.

6. Use the

MAC ACL

drop-down menu to select an MAC ACL used as the MAC IP for the layer 2 interface.

7. Refer to the

Status

field for the current state of the requests made from applet. This field displays error

messages if something goes wrong in the transaction between the applet and the switch.

8. Click

OK

to use the changes to the running configuration and close the dialog.

9. Click

Cancel

to close the dialog without committing updates to the running configuration.

6.5.4 Attaching an ACL on a WLAN Interface/Port

Use the Attach- WLAN tab to view and assign an ACL to a WLAN on the switch. By default, arp is not
supported. Create a MAC ACL to allow arp on the switch.

To configure a WLAN ACL:

1. Select

Security

>

ACLs

from the main menu tree.

2. Click the

Attach-WLAN

tab.

NOTE: WLAN based ACLs allows users to enforce rules/ACLs on both the inbound and
outbound direction, as opposed to L2 ACLs, which just support the inbound direction.