2 ap intrusion detection, 1 enabling and configuring ap detection, 2 ap intrusion detection -3 – Motorola Series Switch WS5100 User Manual
Page 227: 1 enabling and configuring ap detection -3, Ap intrusion detection
Switch Security
6-3
6.2 AP Intrusion Detection
Use the
Internet Protocol
sub-menu to view and configure network related IP information. The Internet
Protocol screen consists of the following tabs:
•
Enabling and Configuring AP Detection
•
Approved APs (Reported by APs)
•
Unapproved APs (Reported by APs)
•
Unapproved APs (Reported by MUs)
6.2.1 Enabling and Configuring AP Detection
Use the
Configuration
screen to enable the switch to detect potentially hostile access points, set the
number of detected APs allowed and define the timeout and threshold values used for detection. The switch
enables both access ports and MUs to scan and detect access points within the switch managed network.
Continually re-validating the credentials of associated access points reduces the possibility of an access
point hacking into the switch managed network.
To configure AP Detection:
1. Select
Security
>
Access Port Intrusion Detection
from the main menu.
2. Select the
Configuration
tab.