beautypg.com

1 viewing the detailed contents of a config file – Motorola Series Switch WS5100 User Manual

Page 61

background image

Switch Information

3-17

2. To view the entire contents of a config file in detail, select a config file by selecting a row from the table

and click the

View

button. For more information, see

Viewing the Detailed Contents of a Config File on

page 3-17

.

3. To modify a configuration file name and/or use it as the configuration at startup, select a row (other than

the start-up-config or running config) from the table and click the

Edit

button. For more information, see

Editing a Config File on page 3-18

.

4. To permanently remove a file from the list of configurations available to the switch, select a configuration

file name from the table and click the

Delete

button.

If startup-config is deleted, a prompt displays stating the default switch startup-config will automatically
take its place. The switch running-config cannot be deleted.

5. To restore the system’s default configuration file and revert the settings back to their factory default, click

the

Restore Defaults

button.

6. Click the Transfer Files button to move a target configuration file to a secure location for later use. For

more information, see

Transferring a Config File on page 3-19

.

3.3.1 Viewing the Detailed Contents of a Config File

The View screen displays the entire contents of a configuration file. Motorola recommends a file be reviewed
carefully from the View screen before it is selected from the Config Files screen for edit or designation as
the switch startup configuration.

1. Select a configuration file from the Configuration screen by highlighting the file.

2. Click the

View

button to see the contents of the selected configuration file.

Created

Displays the date and time each configuration file was created. Use this information as a
baseline for troubleshooting problems by comparing event log data with configuration file
creation data.

Modified

Displays the date and time each configuration file was last modified. Compare this column
against the Created column to discern which files were modified and make informed
decisions whether existing files should be further modified or deleted.

NOTE: Selecting either the startup-config or running-config does not enable the Edit
button. A different configuration file must be available to enable the Edit button for the
purposes of replacing the existing startup-config.

NOTE: After setting the switch to revert to factory default settings, the system must be
rebooted before the factory default settings will take effect. When this occurs, the switch
IP address may change.