FUJITSU SPARC T5440 - Manual (Page 93)

Preparing to Service the System 67
4. While squeezing the slide rail locks, slowly pull the server forward until it is
locked in the service position.
Removing the Server From the Rack
The server must be removed from the rack to remove or install the following
components:
■ Motherboard
Caution – Two people must dismount and carry the chassis.
FIGURE: Lift Warning
Related Information
■ “Front Panel Diagram” on page 3
■ “Rear Panel Diagram” on page 5
■ “Extend the Server to the Maintenance Position” on page 66
■ “Remove the Server From the Rack” on page 67
▼ Remove the Server From the Rack
1. Disconnect all the cables and power cords from the server.
2. Extend the server to the maintenance position.
See “Extending the Server to the Maintenance Position” on page 65 .