FUJITSU SPARC T5440 - Manual (Page 80)

54 SPARC Enterprise T5440 Server Service Manual • July 2009
show /SP/console/history consolehistory [-b lines|-e lines|-v]
[-g lines] [boot|run]
The following options enable you to
specify how the output is
displayed:
• -g lines specifies the number of
lines to display before pausing.
• -e lines displays n lines from the
end of the buffer.
• -b lines displays n lines from the
beginning of the buffer.
• -v displays the entire buffer.
• boot|run specifies the log to
display (run is the default log).
Displays the contents of the
system’s console buffer.
set
/HOST/bootmode/ value[normal|re
set_nvram|bootscript=string]
bootmode value
[normal|reset_nvram|
bootscript=string] Enables control of the firmware
during system initialization with
the following options:
• normal is the default boot mode.
• reset_nvram resets OpenBoot
PROM parameters to their
default values.
• bootscript=string enables the
passing of a string to the boot
command.
stop/SYS; start/SYS powercycle [-f]
The -f option forces an immediate
poweroff. Otherwise the command
attempts a graceful shutdown. Performs a poweroff followed by
poweron
.
stop/SYS poweroff [-y] [-f]
• -y enables you to skip the
confirmation question.
• -f forces an immediate
shutdown.
Powers off the host server.
start/SYS poweron [-c]
• -c executes a console command
after completion of the poweron
command.
Powers on the host server.
TABLE: Service-Related Commands (Continued)
ILOM Command ALOM CMT Command Description