FUJITSU SPARC T5440 User Manual
Page 210

184
SPARC Enterprise T5440 Server Service Manual • July 2009
power distribution board, 126
power supply, 86, 89
server from rack, 67
service processor, 120
reset, system
using ILOM, 28
using POST commands, 28
S
safety information, 59
safety symbols, 60
sanity check for hardware components, 19
SCC module
and host ID, 2
and MAC addresses, 2
serial management port
serial number, chassis, 62
serial port (DB-9)
service processor
Service Required (system LED), 32
about, 4
cleared by enablecomponent command, 48
interpreting to diagnose faults, 31
triggered by ILOM, 15
triggered by power supply fault, 92
set
command
and component_state property, 48
setkeyswitch
and faults detected by POST, 35
and PSH faults, 34
and Service Required LED, 32
description and examples, 32
environmental fault, 34
reasons to use, 33
use in detecting faults in an External I/O
using to check for faults, 12
using to diagnose FB-DIMMs, 106
using to verify successful FB-DIMM
showfaults
command
showlocator
shutdown
triggered by top cover removal (emergency
using Power button (emergency shutdown), 5
using Power button (graceful shutdown), 5
using powercycle command (graceful
using powercycle -f command (emergency
using poweroff command, 54
slide rail latch, 66
Solaris log files, 12
Solaris log files as diagnostic tool, 12
Solaris OS
checking log files for fault information, 12
collecting diagnostic information from, 35
message buffer, checking, 36
message log files, viewing, 36
Solaris Predictive Self-Healing, 17
SunVTS, 18
as fault diagnosis tool, 12
browser environment, 40
Component Stress parameter, 40
exercising the system with, 38
software packages, 41
System Excerciser, 40
tests, 42
user interfaces, 38, 39, 41, 42
using for fault diagnosis, 12
verifying installation, 38
system bus topology, 162
system console, 23
system console, switching to, 23
system controller, 10