FUJITSU SPARC T5440 - Manual (Page 149)

Servicing Field-Replaceable Units 123
Next Steps
■ “Install the Top Cover” on page 150
■ “Slide the Server Into the Rack” on page 151
■ “Connect the Power Cords to the Server” on page 153
■ “Power On the Server” on page 153
Servicing the IDPROM
The IDPROM stores system parameters, such as host ID and MAC address, ILOM
configuration settings, and OpenBoot PROM configuration settings. If you are
replacing a faulty service processor, you must move the IDPROM from the old
service processor to the new one.
Related Information
■ “Servicing the Service Processor” on page 120
■ “Servicing the Battery” on page 125
▼ Remove the IDPROM
Before you begin, complete these tasks:
■ Read the section, “Safety Information” on page 59 .
■ Power off the server, using one of the methods described in the section, “Powering
Off the System” on page 63 .
■ “Extend the Server to the Maintenance Position” on page 66
■ “Disconnect Power Cords From the Server” on page 65
■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 69
■ “Remove the Top Cover” on page 69
■ “Remove the Service Processor” on page 120
1. Lift the IDPROM up, off its connector on the service processor.