FUJITSU SPARC T5440 - Manual (Page 55)

Managing Faults 29
4. Switch to the system console to view the POST output:
If no faults were detected, the system will boot.
CODE EXAMPLE: POST Output (Abridged) on page 29 depicts abridged POST
output.
-> start /SP/console
CODE EXAMPLE: Initiating POST With a Power Cycle
-> stop /SYS
Are you sure you want to stop /SYS (y/n)? y
Stopping /SYS
-> start /SYS
Are you sure you want to start /SYS (y/n)? y
Starting /SYS
CODE EXAMPLE: POST Output (Abridged)
-> start /SP/console
...
2007-12-19 22:01:17.810 0:0:0>INFO: STATUS: Running RGMII 1G
BCM5466R PHY level Loopback Test
2007-12-19 22:01:22.534 0:0:0>End : Neptune 1G Loopback Test -
Port 2
2007-12-19 22:01:22.553 0:0:0>
2007-12-19 22:01:22.542 0:0:0>Begin: Neptune 1G Loopback Test -
Port 3
2007-12-19 22:01:22.556 0:0:0>INFO: STATUS: Running BMAC level
Loopback Test
2007-12-19 22:01:32.004 0:0:0>End : Neptune 1G Loopback Test -
Port 3
2007-12-19 22:01:27.271 0:0:0>
T5440, No Keyboard
Enter #. to return to ALOM.
2007-12-19 22:01:32.012 0:0:0>INFO:
2007-12-19 22:01:27.274 0:0:0>INFO: STATUS: Running RGMII 1G
BCM5466R PHY level Loopback Test
OpenBoot ..., 7968 MB memory available, Serial #75916434.
2007-12-19 22:01:32.019 0:0:0>POST Passed all devices.
[stacie obp #0]
2007-12-19 22:01:32.028 0:0:0>POST:Return to VBSC.
Ethernet address 0:14:4f:86:64:92, Host ID: xxxxx
2007-12-19 22:01:32.036 0:0:0>Master set ACK for vbsc runpost
command and spin...
{0} ok