FUJITSU SPARC T5440 - Manual (Page 82)

56 SPARC Enterprise T5440 Server Service Manual • July 2009
TABLE: ALOM CMT Parameters and POST Modes on page 56 shows typical
combinations of ALOM CMT variables and associated POST modes.
(No ILOM equivalent.) showfru [-g lines] [-s | -d] [FRU]
• -g lines specifies the number of
lines to display before pausing
the output to the screen.
• -s displays static information
about system FRUs (defaults to
all FRUs, unless one is specified).
• -d displays dynamic information
about system FRUs (defaults to
all FRUs, unless one is specified).
See
“Display Individual
Component Information With the
ILOM show Command” on
page 25
.
Displays information about the
FRUs in the server.
show /SYS/keyswitch_state showkeyswitch Displays the status of the virtual
keyswitch.
show /SYS/LOCATE showlocator Displays the current state of the
Locator LED as either on or off.
show /SP/logs/event/list showlogs [-b lines | -e lines |
-v]
[-g lines] [-p
logtype[r|p]] ]
Displays the history of all events
logged in the service processor
event buffers (in RAM or the
persistent buffers).
show /SYS showplatform [-v] Displays information about the
operating state of the host system,
the system serial number, and
whether the hardware is providing
service.
TABLE: ALOM CMT Parameters and POST Modes
Parameter
Normal Diagnostic Mode
(Default Settings)
No POST Execution
Diagnostic Service
Mode Keyswitch Diagnostic
Preset Values
diag mode normal Off service normal
keyswitch_state normal normal normal diag
diag_level max N/a max max
TABLE: Service-Related Commands (Continued)
ILOM Command ALOM CMT Command Description