FUJITSU SPARC T5440 User Manual
Page 61
Managing Faults
35
■
Example showing a fault that was detected by POST. These kinds of faults are
identified by the message Forced fail reason where reason is the name of the
power-on routine that detected the failure.
■
Example showing a fault in the External I/O Expansion Unit. These faults can
be identified by the text string Ext FRU or Ext sensor at the beginning of the
fault description.
The text string Ext FRU indicates that the specified FRU is faulty and should
be replaced. The text string Ext sensor indicates that the specified FRU
contains the sensor that detected the problem. In this case, the specified FRU
may not be faulty. Contact service support to isolate the problem.
Detecting Faults Using Solaris OS Files and
Commands
With the Solaris OS running on the server, you have the full complement of Solaris
OS files and commands available for collecting information and for troubleshooting.
If POST, ILOM, or the Solaris PSH features do not indicate the source of a fault, check
the message buffer and log files for notifications for faults. Hard drive faults are
usually captured by the Solaris message files.
Use the dmesg command to view the most recent system message. To view the
system messages log file, view the contents of the /var/adm/messages file.
-> show faulty
Target
| Property
| Value
--------------------+------------------------+--------------------------------
/SP/faultmgmt/0 | fru | /SYS/MB/CPU0/CMP0/BR1/CH0/D0
/SP/faultmgmt/0 | timestamp | Dec 21 16:40:56
/SP/faultmgmt/0/
| timestamp
| Dec 21 16:40:56
faults/0 | |
/SP/faultmgmt/0/
| sp_detected_fault
| /SYS/MB/CPU0/CMP0/CMP0/BR1/CH0/D0
faults/0 | Forced fail(POST)
-> show faulty
Target | Property | Value
--------------------+------------------------+--------------------------------
/SP/faultmgmt/0 | fru | /SYS/IOX@X0TC/IOB1/LINK
/SP/faultmgmt/0 | timestamp | Feb 05 18:28:20
/SP/faultmgmt/0/ | timestamp | Feb 05 18:28:20
faults/0 | |
/SP/faultmgmt/0/
| sp_detected_fault
| Ext FRU /SYS/IOX@X0TC/IOB1/LINK
faults/0
|
| SIGCON=0 I2C no device response