FUJITSU SPARC T5440 - Manual (Page 144)

118 SPARC Enterprise T5440 Server Service Manual • July 2009
■ If you performed any additional service procedures, see “Power On the Server” on
page 153 .
Servicing the DVD-ROM Drive
You must remove the front bezel before servicing the DVD-ROM drive.
Related Information
■ “Servicing the Front Bezel” on page 115
▼ Remove the DVD-ROM Drive
Before you begin, complete these tasks:
■ Read the section, “Safety Information” on page 59 .
■ Power off the server using one of the methods described in the section, “Powering
Off the System” on page 63 .
■ “Extend the Server to the Maintenance Position” on page 66
■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 69
■ “Remove the Top Cover” on page 69
■ “Remove the Front Bezel” on page 116
Do the following:
1. Remove the flex cable retainer.
Loosen the captive No. 2 Phillips screw and lift the retainer up and out of the
chassis.
2. Unplug the DVD-ROM drive from the flex cable assembly.
3. Push the DVD-ROM drive forward until it protrudes from the front of the
chassis.