FUJITSU SPARC T5440 - Manual (Page 151)

Servicing Field-Replaceable Units 125
● Plug the IDPROM into its connector on the service processor.
Ensure that the service processor is oriented correctly. A notch on the IDPROM
corresponds to a similar notch on the connector.
Servicing the Battery
The battery provides the power necessary to maintain system configuration
parameters during power outages, or while the system is being serviced, stored or
relocated.
Related Information
■ “Servicing the Service Processor” on page 120
■ “Servicing the IDPROM” on page 123
▼ Remove the Battery
Before you begin, complete these tasks:
■ Read the section, “Safety Information” on page 59 .
■ Power off the server, using one of the methods described in the section, “Powering
Off the System” on page 63 .
■ “Extend the Server to the Maintenance Position” on page 66
■ “Disconnect Power Cords From the Server” on page 65
■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 69
■ “Remove the Top Cover” on page 69
■ “Remove the Service Processor” on page 120
1. Release the latch securing the battery to its holder on the service processor
board.
2. Lift the battery up and off the board.
▼ Install the Battery
1. Place the battery into its holder on the service processor board.
Ensure that the battery is oriented correctly.