Disable system components, Re-enable system components – FUJITSU SPARC T5440 User Manual

Page 78

SPARC Enterprise T5440 Server Service Manual • July 2009

▼ Disable System Components

The component_state property disables a component by adding it to the ASR
blacklist.

1. At the -> prompt, set the component_state property to Disabled:

2. Reset the server so that the ASR command takes effect.

Note –

In the ILOM shell there is no notification when the system is actually

powered off. Powering off takes about a minute. Use the show /HOST command to
determine if the host has powered off.

▼ Re-Enable System Components

The component_state property enables a component by removing it from the ASR
blacklist.

1. At the -> prompt, set the component_state property to Enabled.

2. Reset the server so that the ASR command takes effect.

-> set /SYS/MB/CPU0/CMP0/BR1/CH0/D0 component_state=Disabled

-> stop /SYS

Are you sure you want to stop /SYS (y/n)? y

Stopping /SYS

-> start /SYS

Are you sure you want to start /SYS (y/n)? y