FUJITSU SPARC T5440 - Manual (Page 150)

124 SPARC Enterprise T5440 Server Service Manual • July 2009
FIGURE: Removing the IDPROM
2. Place the IDPROM on an antistatic mat.
▼ Install the IDPROM
Before you begin, complete these tasks:
■ Read the section, “Safety Information” on page 59 .
■ Power off the server, using one of the methods described in the section, “Powering
Off the System” on page 63 .
■ “Extend the Server to the Maintenance Position” on page 66
■ “Disconnect Power Cords From the Server” on page 65
■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 69
■ “Remove the Top Cover” on page 69
■ “Remove the Service Processor” on page 120