FUJITSU SPARC T5440 - Manual (Page 125)

Servicing Customer-Replaceable Units 99
Related Information
■ “CMP and Memory Module Device Identifiers” on page 103
■ “Supported CMP/Memory Module Configurations” on page 104
■ “I/O Connections to CMP/Memory Modules” on page 156
■ “Reconfiguring I/O Device Nodes” on page 158
■ “Servicing FB-DIMMs” on page 104
■ “System Bus Topology” on page 162
■ “I/O Fabric in 2P Configuration” on page 164
■ “I/O Fabric in 4P Configuration” on page 165
▼ Remove a CMP/Memory Module
Before you begin, complete these tasks:
■ Read the section, “Safety Information” on page 59 .
■ Power off the server, using one of the methods described in the section, “Powering
Off the System” on page 63 .
■ “Extend the Server to the Maintenance Position” on page 66
■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 69
■ “Remove the Top Cover” on page 69
Do the following :
1. Identify the module you want to remove.
2. Rotate the ejector levers up and away from the module.