FUJITSU SPARC T5440 - Manual (Page 114)

88 SPARC Enterprise T5440 Server Service Manual • July 2009
FIGURE: Installing a Power Supply
3. Reconnect the power cord to the power supply.
Verify that the power supply LED is green or blinking green.
4. Verify that the system Power Supply Fault LED, and the front and rear Service
Required LEDs are not lit.
Note – See “Front Panel LEDs” on page 4 and “Rear Panel LEDs” on page 7 for more
information about identifying and interpreting system LEDs.
5. At the ILOM -> prompt, use the show faulty command to verify the status of
the power supplies.