Yaskawa Sigma II Series SGMVH - Manual (Page 328)

11 Appendix
11.3.2 List of Parameters
11-26
Pn50D Input Signal Selections 4 − − 8888 After restart
Pn50E Output Signal Selections 1 − − 3211 After restart
Parameter
No.
Name Setting Range Unit
Factory
Setting
Setting
Validation
0
1
2
3
0 to F Same as /ZCLAMP
Same as /ZCLAMP
ON when CN1-40 input signal is ON (L-level).
ON when CN1-41 input signal is ON (L-level).
ON when CN1-42 input signal is ON (L-level).
ON when CN1-43 input signal is ON (L-level).
ON when CN1-44 input signal is ON (L-level).
ON when CN1-45 input signal is ON (L-level).
ON when CN1-40 input signal is OFF (H-level).
ON when CN1-41 input signal is OFF (H-level).
ON when CN1-42 input signal is OFF (H-level).
ON when CN1-43 input signal is OFF (H-level).
ON when CN1-44 input signal is OFF (H-level).
ON when CN1-45 input signal is OFF (H-level).
ON when CN1-46 input signal is OFF (H-level).
ON when CN1-46 input signal is ON (L-level).
/ZCLAMP Signal Mapping (Zero clamp when ON (L-level))
/INHIBIT Signal Mapping (Reference pulse inhibit when ON (L-level))
/G-SEL Signal Mapping (Gain change when ON (L-level))
Reserved (Do not change)
4th
digit 3rd
digit 2nd
digit 1st
digit
n.
0 to F
4
5
6
7
8
9
A
B
C
D
E
F
Sets signal OFF.
Sets signal ON.
0
1
2
3
0 to 3
Disabled (the above signal is not used.)
Outputs the signal from CN1-25, 26 output terminal.
Outputs the signal from CN1-27, 28 output terminal.
Outputs the signal from CN1-29, 30 output terminal.
Same as /COIN
Same as /COIN
Same as /COIN
Positioning Completion Signal Mapping (/COIN)
Speed Coincidence Detection Signal Mapping (/V-CMP)
Rotation Detection Signal Mapping (/TGON)
Servo Ready Signal Mapping (/S-RDY)
4th
digit 3rd
digit 2nd
digit 1st
digit
n.
0 to 3
0 to 3