HEIDENHAIN TNC 415 (259 9x0) Service Manual - Manual (Page 98)

SERVICE MANUAL TNC 415B/425
Page 93
Issue: 20.08.95
16.3.4 Error Messages at the TNC in the FE Mode
In this operating mode, the floppy disk unit outputs errors in the following format:
(SOH) ERR: (SP) (SP) (SP) [XXX] (ETB) (BCC)
XXX = error number
The following errors can be displayed on the screen:
Input/Output Errors
ERR: 001 = wrong command code
ERR: 002 = illegal program name
ERR: 003 = faulty data transfer
ERR: 004 = program incomplete
ERR: 005 = receiving buffer overflow
ERR: 006 = function currently disabled
ERR: 007 = data-buffer overflow
Errors during Program Write or Read
ERR: 010 = program not on disk
ERR: 011 = program erase-protected
ERR: 012 = program is being written to
ERR: 013 = program directory is full
ERR: 014 = disk is full
ERR: 015 = text not found
ERR: 016 = program name already exists
ERR: 017 = disk access active
ERR: 018 = program currently being read
Disk / Drive / Controller Errors
ERR: 100 = disk not initialized
ERR: 101 = sector number too large
1)
ERR: 102 = drive not ready 2)
ERR: 103 = disk is write-protected
ERR: 104 = faulty data on disk
1)
ERR: 105 = sector cannot be found 1)
ERR: 106 = check sum incorrect 1)
ERR: 107 = disk controller defective 3)
ERR: 108 = DMA defective 3)
ERR: 109 = disk exchanged during program loading
1) These error messages indicate that the disk is defective; in most cases, they can only be
eliminated by formatting the disk anew.
2) If this error message comes up while the disk is inserted, the drive is probably defective.
3) Hardware defect