HEIDENHAIN TNC 415 (259 9x0) Service Manual - Manual (Page 97)

SERVICE MANUAL TNC 415B/425
Page 92
Issue: 20.08.95
16.3.3 Error Messages at the FE in the ME-Mode
In the ME-mode, errors are displayed by blinking indicator lamps (LEDs).
{ LED off z LED on ’ LED blinking
Indicator Lamp Error Message
{{{z
{’{{
Disk missing or error in the ME electronics
{{{’
{’{{
Disk cannot be formatted, as it is currently being used
’{{z
’{{{
Disk missing or not formatted
’{{’
’{{{
Disk cannot be copied, as a read/write process is active
z{’z
{{{{
External unit not ready or not connected
’{zz
{{{{
Disk missing or not formatted
’{{z
{{z{
Disk missing or not formatted or no program available
’{z’
{{{{
Program cannot be output, as a transfer is active via the TNC interface
’{{’
{{z{
Program cannot be output, as a transfer is active via the PRT interface
{{’z
z{{{
External unit not ready or not connected
{{zz
’{{{
Disk missing or not formatted
{{{z
’{z{
Disk missing or not formatted
{{z’
’{{{
Program cannot be output, as a transfer is active via the TNC interface
{{{’
’{z{
Program cannot be output, as a transfer is active via the PRT interface
{z{z
{{’{
External unit not ready or not connected
{’{z
{{z{
Disk missing or error in the ME electronics
{’{’
{{z{
Table of contents cannot be output, as a transfer is active via the PRT interface
{{{’
{{z{
No interface coupling possible, as a transfer is active via the TNC interface
{{z’
{{{{
No interface coupling possible, as a transfer is active via the PRT interface
{{’z
{{{{
External unit not ready or not connected
By pressing
STOP
the error messages can be cleared.