HEIDENHAIN TNC 415 (259 9x0) Service Manual - Manual (Page 118)

SERVICE MANUAL TNC 415B/425
Page 113
Issue: 20.08.95
When the error message
OPERATING PARAMETERS ERASED
is displayed, enter the machine parameter file .MP as follows:
(see section 2.1)
Press Key Function
CE
MOD
EXT
interface mode
FE1
otherwise
...
Clear the error message
OPERATING PARAMETERS ERASED
Configure the interface (see section16.1)
Activate the data transfer menu.
If necessary: select the desired MP file by pressing the
arrow keys.
Enter the name of the MP file (ASCII or numerical keys).
Start data transfer.
Exit the data transfer menu.
END
The machine parameter file loaded in the editor is activated
(receives the status M, see section 17.3.3).